ReferĬonfiguration Guide for more information about AppleTalk Cayman tunneling. Interface and configure the packet source off of the loopback interface. ![]() Specific 12.2SX release of this train depends on your feature set, platform,Ĭommand was introduced on Cisco ASR 1000 Series Routers.Ĭommand was integrated into Cisco IOS Release 15.1SY.Ĭommand was implemented on the Cisco ASR 901 Series Aggregation ServicesĬonfigure two tunnels to use the same encapsulation mode with exactly the same The address field was modified to accept anĪrgument to allow IPv6 nodes to be configured as a tunnel destination.Ĭommand was integrated into Cisco IOS Release 12.2(30)S.Ĭommand was integrated into Cisco IOS Release 12.2(28)SB.Ĭommand was integrated into Cisco IOS Release 12.2(25)SG.Ĭommand was integrated into Cisco IOS Release 12.2(33)SRA.Ĭommand is supported in the Cisco IOS Release 12.2SX train. The tunnel destination address dynamically to the tunnel interface.Ĭommand was modified. ![]() Tunnel bandwidth Īddress of the host destination expressed in dotted decimal notation.Īddress of the host destination expressed in IPv6 address format. To restore the default setting, use the no form of this command. To set the transmit bandwidth used by the tunnel interface, use the tunnel bandwidth command in interface configuration mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |